As described on the right. Triple slit and hardened.
1 each of 1.0 - 1.5 - 2.0 - 2.4 - 3.0 and 3.2mm.
With clamping nut and holder for storage.
NO 28 940
Note:
Our drill chuck (NO 28 941) provides more convenience to quickly change the tools when working with shafts of varying diameters (e.g. HSS drills as per DIN 338). However, because of their technical setup, they have a few drawbacks compared to collets: Less clamping force and higher concentricity tolerances. If high precision is necessary, then working with MICROMOT steel collets is a must.
Easily clamps to workbenches and tables of up to
In our catalogue section “Special Analysis”
In general, stirring is used to adjust
JM-V press brake provides an economical solution
For more information don't hesitate to contact us.
Contact us